Contact Us|Terms of Service|Privacy & Security|About Us|Our Network|Sitemap © 2003-2016 JustAnswer LLC JustAnswer UKJustAnswer GermanyJustAnswer SpanishJustAnswer Japan 51 4952864 View Cart| Contact Us| Track Order| Customer Service| My Account Discuss Error I hope your oven doesn't cause you too much trouble.

Check for plugged or kinked inlet hoses, as well as plugged screens in the inlet valves.

I got 240 volts at outlet. If failure remains, disconnect power, replace control, then go back to step 2. Expert: Bob L Your Appl Pal replied6 years ago. Whirlpool Stove Error Codes Sometimes you can remove the two 1/4 screws and pull it inside then disconnect it.

Note: If this failure occurs during high-speed spin, the door will be unlocked after three minutes. Check the drive belt and reconnect power and plug unit in. All rights reserved. http://permanentfatalerror.com/error-code/whirlpool-gold-error-code-e2-f1.php Check wire harness connections to pressure switch, drain pump, and Central Control Unit (CCU).

Thanks! Thanks in advance' D. #4 (permalink) 08-23-2010, 08:34 PM Gene Senior Expert APP Volunteer Join Date: Jul 2007 Location: Orange County, California Posts: 27,234 This instructions made by As I understand it, electrical noise/ interference from the spark module is causing problems in the very nearby (and expensive to replace) 'oven control board'. See Details Kenmore 40272 24" Manual Clean Electric Wall ...

Check drain pump and pressure switch and verify CCU operation by running a diagnostic test or any cycle. It's free! If you are still getting the F1 F2, then I would suspect the keypad. ob - Off Balance - The lid switch must be opened at least once before reseting the cycle.

© Copyright 2017 permanentfatalerror.com. All rights reserved.